Denon zone 2 pre out setup. How can I set my AVR so I can only control the volume for ZONE 2 PRE-OUT from the amplifier it's connected to? By default the volume level for ZONE2 PRE-OUT can. Then, click on the “View Terminal Config” tab to see where your speakers or RCA connections need to be connected. This step-by-step guide will walk you through the process of setting up and using Zone 2 on your Denon receiver, from connecting the necessary cables to adjusting the volume and selecting the desired audio source. Entry levels might not have the ability to do preout only. The setup for Zone 2 and Zone 3 is fairly easy. From there, use your remote control to power on Zone 2, Zone 3 or both and control the volume for each discrete Zone. I'd like to connect two sets of speakers so, this is the only way I can think to make it work. When the same input source is set for both MAIN ZONE and ZONE2, PCM 2-channel is used for the audio in MAIN ZONE too. A selling point was the Zone 2 Pre-out because I wanted to connect to a stereo amp for running several in-ceiling speakers throughout the house. Values set for “Volume Limit” and “Power On Volume” are displayed according to the setting specified for the volume “Scale”. z4ywywea na5vj 3ki ni6 4u2h4m ctsg o0d oli5wlj in8rm5z ru